LAMGROW(1)                       LAM COMMANDS                       LAMGROW(1)


       lamgrow - Extend a LAM multicomputer.


       lamgrow  [-hvd]  [-cpu  <num>] [-n <nodeid>] [-no-schedule] [-ssi <key>
              <value>] <hostname>


       -cpu <num>    Indicate how many CPUs are available to LAM  on  the  new

       -d            Turn on debugging output.  This implies -v.

       -h            Print useful information on this command.

       -n <nodeid>   Assign this ID to the new node.

       -no-schedule  Indicate  that  C  and  N expansion in mpirun and lamexec
                     should not schedule on this node.

       -ssi <key> <value>
                     Send arguments to various SSI  modules.   See  the  "SSI"
                     section, below.

       -v            Be verbose.

       <hostname>    Extend LAM with this host.


       An  existing  LAM universe, initiated by lamboot(1), can be enlarged to
       include more nodes with lamgrow.  One new node is added for each  invo-
       cation.  At a minimum, the host name that will run the new node is giv-
       en on the command line.  If a different userid is  required  to  access
       the  host,  it  is specified with the appropriate boot SSI options (see

       The new node can be assigned any unused, non-negative  identifier.   If
       no  identifier is specified, the highest node identifier in the current
       LAM universe plus one is used.  Note  that  lamboot(1)  always  assigns
       node identifiers consecutively from 0.

       lamgrow can be run from any node in the current LAM universe.  Specifi-
       cally -- it cannot be run from the intended new host.  Two  invocations
       of lamgrow should not run concurrently, and the command attempts to de-
       tect this situation. The name of the host specified in  lamgrow  should
       not  be the one which is already present in the user’s LAM universe and
       the command attempts to detect this situation too.

       Resource managers will be the most common user of lamgrow.  When  hosts
       become idle and a user has expressed a desire to the manager that extra
       cycles should be exploited, the manager could invoke lamgrow  and  then
       launch the specified application process(es) on the new node.


       lamgrow -v newhost
           Start  LAM  on  newhost  and  add  it to the existing LAM universe.
           Choose the next available node identifier and report  about  impor-
           tant steps as they are done.

       lamgrow -n 30 newhost
           Start LAM on newhost with node ID 30 and add it to the existing LAM
           universe.  Operate silently.


       laminstalldir/etc/lam-conf.lamd   default configuration  file  for  LAM
                                         nodes,  where  "laminstalldir" is the
                                         directory  where  LAM/MPI   was   in-


       It is not currently possible to specify a configuration file other than
       lam-conf.lamd on the remote node, even though  this  is  possible  with


       lamboot(1),   lamhalt(1),  hboot(1),  lamwipe(1),  tkill(1),  bhost(5),
       conf(5), lamssi_boot(7)

LAM 7.1.1                       September, 2004                     LAMGROW(1)

Man(1) output converted with man2html